Where and how to charge powder

Operation guide
Step 1. Be sure that the device is on standby.
Step 2. Unscrew off the cover.

Step 3. Pour powder into the case. The level of the powder is lower than the orifices. Don’t sink the orifices. 20g is optional.

Step 4. Put on the cover. Be sure to screw smoothly and thoroughly, then tighten it and check it. Rickety cover is subject to be throw out, or may cause serious harm.


Step 5. Make sure water pressure and air pressure are within the range requested.
It is recommended that the patient and the operator wear eye-protectors.
Step 6. The nozzle aims at the stain at the distance of 1 to 3mm then step on foot switch.
It is advised to move nozzle as small circles, avoid jetting tissues during treatment.
Step 7.During treatment, rotate handpieces to adjust the direction of jet flow.
Step 8. Release foot switch, wait a moment till the nozzle stops jetting powder, withdraw propjet polisher.